1/20th scale Schnellboot Rudder and Strut Set


This is the 1/20th scale Schnellboot rudder and strut kit.

The rudders are made from Cast Silicon Bronze and have a vertical drive shaft of just less than 4mm (5/32") and will need to be covered with a section of  K&S metals 3/16" thick walled tubing and soldered in place then it will fit into a standard Radio Active MA 3062 Mini Rudder fitting (or similar) in place of the flat blade that is supplied.

The centre and mirrored side struts are also cast in Silicon Bronze and have a propshaft hole just under 4mm so they can be drilled out or bored out to 4mm or 5/32".

All the cast parts have a casting sprue, as shown,  that needs to be filed off and sanded as shown on the two side struts shown on the right hand side.


The package

I send all packages with tracking so that they don't get lost. Often packages are held at the customer's local Post Office as they can be too large for the customers mailbox, so if it has been a week or more since I notified you about shipment, please check with your Post Office. If I receive an attempted delivery message I will email you. If you don't pick it up after a couple of attempted deliveries it will likely get returned to us.

All packages are marked with the international Harmonised code for Reduced Scale Model Kits - HS950320.


The total price includes tracked parcel postage to most places in Australia, New Zealand, Canada, the US, UK or Europe.



© Copyright 2019 John Drain